the 570 is 4gb, i put in the rig to show the point that DPM1 dont work
thank you
i have tried the asus bios on my gigabyte, works, but every few hours the fan speed becomes 0%. but as usual, YMMV, diff cards react differently, maybe mine just doesnt take it.
didn’t know thanks for the info
When I enter this in I get Command ‘upp’ not found did you mean: then a list of other commands
apt install python3-pip
pip3 install upp
Than you!
how do u get so low temps on ur vram? my core temp is always below 50, but my vram temps always 70!
i did it but it gives only 45 mhs. rx 6800 sapphire
i notice if i use amd-info to check my SocMhz, anything above 800 and my hashrates drop drastically, i also use --eth_config=A928 in my teamredminer config, dont noe if it will help u
Some run in conditioned rooms or colder climates.
I have 2x 6800 and 2x 6800xt; all cores between 45 and 50°C. One 6800 and one 6800xt have mem around 60°C, one 6800xt mem at 70°C and one 6800 mem at 80°C.
All running in the same rig, so I guess luck also has to do something with it.
Maybe some day I’ll add some thermal pads to the worse one to link the memory to the backplate for better heat dissipation.
Nevertheless, 80°C isn’t that bad, I think they can take much higher also.
ah, tried AC, but the room wont cool down 
No, the amount of power you put in an AC and the benefits you gain from it are IMO not worth it.
You better invest in a good industrial fan to extract the heat out of the room.
shoul i put this command hiveos web interface “run command” ? or should i put these command in hiveshell?
Finally found time to do the script. This rig was doing 441 MHs in Windows using PhoenixMiner. Couldn’t get PhoenixMiner to work in Hive and NBMiner and TRM were not giving me the results which I liked. I am using GMiner now.
The problematic card below is a Gigabyte Gaming OC:
Other cards are Powercolor Fighter, Red Dragon, and a couple more Gigabyte Gaming OC’s. Will try to do some more OC tweaks in the next 24 hours.
hey, what miner are you using ?
hey guys,
someone has overclock settings for windows ? somehow i don’t get above 57mh/s on win10 with amd stock ref 6800. sometimes it goes up to 62 but most of the time it’s at 57.
i have 1 gigabyte oc that doesn like core voltage below 700, and another card that does not like mem voltage above 1270. have to tinker until u find the best for each card…
After a few hours of playing around with OC settings, this has been the most stable. Will clap back here if this can’t go over 24 hours.
This is using GMiner. It isn’t as efficient as TeamRedMiner (gets less MHs but also uses a lot less watts) but it does allow me to push the limit on hashrates per card. It’s just a shame that GPU4 isn’t a silicon lottery winner.
EDIT: for those of you who are seeing this for the first time, this setup is only possible if you are able to set the F-state to 1551 using the script below (you will also need HiveOS 0.6-205 or later):