If the temp goes below set point it may go to zero. Mine does sometimes even though my minimum is 25%. But as long as im maintaining 50c im happy
Great thanks again!
GA 104 error. Your system can not recognize the 3070 TI GPU. Most probably you have to upgrade mainboard bios firmware.
What of the 3070 is more cold? Msi gaming x trio / Msi ventus 3x / EVGA 3070 FTW3 Ultra ?? Please…
Gaming X trio is far colder than the ventus, and also more stable. I don’t know about EVGA
You dont need PL when using absolute core settings
1 Like
A 3070ti is LHR. There is no work around.
You didnt know it was low hashrate?
All the new TI models are low hashrate.
If the model number ends in “kL” its low hash rate
1100 core
2700 memory
0 power limit.
Do NOT use 0 power limit with out absolute core settings applied.
I have a msi ventus and 4 Evgas ftw3s. The msi runs higher wattage and not quite as cool…
Evgas are awesome.
So evgas ftw3 are colder then ventuses?
In my case, yes.
GPU 0,1,3 Asus Rog Strix
GPU 2 Aorus Gigabyte
Because of invalid stale make in config Delay (40)
TRex and TRM
Any good suggestions?
1 Like
All looking good, for me the mem should never be above 2500, will onlly give you in the 1€ more per month per card but will also make it run hotter so may brake down fast, other then that temps looking good !
1 Like
try to put the core at 1070 on the one that is having invalid shares and see if it helps, if it doesnt make the mem 2500, other then that everything looks perfecto !
2 Likes
Keeping it is a very good idea tho, if somehow the card try’s to pull more hiveos wont let it, this could prevent a ton of very bad things. plus keeping it at 130 doesnt cost anything.
1 Like
I dont know why people are trying to go past 62 mhs for the 3070. Even if its a little under but your memory doesnt suffer, it will be more stable and offer longer service in the end. Stability and efficiency are far more important than 0.3-0.5 mhs