Set your OC settings to this… 240/2025/145 (core/mem/pl) & your fan at 90%.
If this doesn’t lower your temperatures it’s because you’re not getting enough airflow to the card or it’s to close to other cards.
Take a picture of your rig setup and the card that’s getting hot.
Don’t use core offsets or power limits for best results on lhr cards. Much more stable and lower power draw by using locked core clocks, lower temps/less wear and tear as well.
So don’t PL lhr cards for better efficiency?
A proper locked core clock will have the card only draw the amount of power needed, so limiting power will limit hashrate.
Yeah, most of my 3060 ti lhr cards before pl after OC settings set ran around 152-168 before doing a pl. i just pl because I wanted my efficiency to be better. Which was around the 250’s before power limiting.
So this is before I removed the PL I had set. Think they were at 140
This is after no PL’s set. Lower hr and I’m sure efficiency is around 250 watts/hr
What core clock are you using that lets it go to near 200w??
It’s a 3060 ti lhr 252/2016 (core/mem). That’s the settings I came to once I was OC & got the crash around 280. So I set @ 252 (90%)
Yeah that’s your issue. Set your core clock to around 1400 to 1500mhz instead.
Okay… did that and my hashrate dropped to 41 instead of 43. But only pulling 120 watts now.
Fine tune the clocks per card. Bump the core clock up more if you’re not getting full hashrate.
You should be at 45-50mh if using trex or lolminer, though. Bump the memory up as high as is stable.
I’m using nbMiner. Running a mix of AMD and Nvidia cards.
4x rx6700xt
7x rtx3060ti lhr
1x rtx3090ti
Switch to teamredminer and trex miner or lolminer, or lolminer and teamredminer. Nbminer fluffs the local hashrate to make it look better than it actually is.
Will I have to switch my overclock settings some when I reconfigure my flight sheet?
Also, does this look good? ^^^
Clocks are algo dependent, not miner dependent. So as long as they’re decent settings, no need to change them.
Thank you! I’ll start a new flight sheet when I get home in the morning from work. Thanks, Keaton
Post a picture of your setup of your rig. Let’s see your cards and everything.
I can’t coz i’m not physically there. But it’s not hot, and have a nice distance between cards.
Turn all fans to 100%, add a box fan to the rig, increase exhaust fan for that room etc
