I think these card are by far the best value for money (EUR/MH) now on the market if you can cool them properly. Do you know anything about their MH with different algos? (Only after ETH2.0 of course!)
Could you test it?
is this the case from inter tech 4w2?
the air must be let from the front to the back, therefore the gpu are installed the wrong way round.
The server cases are for the garbage can, if you do not turn the GPU position by 180 degrees, warm air always has to go to the back.
i turned the fans by 180° and the air iway is from the back to the front , this way is perfect, there is no way to turn the gpu by 180° my friend.
you have to take a drill and drill some holes, then you can turn them around, now you pull the warm air from the PSU and motherboard through the GPUs.
So you have to be a bit handy, the construction of the case is a fatal flaw.
I have mines set to PL 68 watts, Mem 2800. They are all happily chugging along at 40.60-40.69 mh/s each.
I haven’t tried overclocking the memory past 3000, but the temps you have on yours looks great.
Before I was running on 1000 core and 3000 mem, but it was “safe” approach when cards were inside a house. Now it’s in a garage without a heating so temps are ok.
I have 10 of these cards, once I run it on 1000/3000 setting, they’ll run at 41.2, but as soon as one starts heating up they start bogging down below 39. That’s why I have mine set to where they are.
put 95% on FAN - these cards love good vent 
I’d just like to source a couple. I had a bead on some the other day, but sold out before I could make the purchase. 
Great result. what is the room temperature?
Hello great results. Can you please show the cooling system or explain how you did it?
Hi,
I use liquid immersion cooling.
Kodos to you, very interesting project. I use chassis fans (one every 2 GPUs, 10 in total) and it’s quite difficult to keep temperatures low, 50° is very good I can’t get lower than 60° with air cooling
How did you get it to recongise your a2000
1 Like