Yes I mine ETH, I did have some problem at the beginning, one of them only reach 12 MH/s, It was the riser connection, try to check them if you use risers. Another thing, for power limit use 170 to start, these cards are power hungry, with that you should be able to reach 40MH or more, and then get the PL down a bit, until you reach the most stable state you can get. It took me some time of testing but right now they are working stable. I use lolminer 1.34 and drivers 470.34
@spencerjw Try to check the risers connection, what miner and drivers you use? I’m with lolminer, the latest version 1.34 and latest nvidia driver 470.34
@0r0chit0 Risers all seem file. Properly seated, USB wires properly seated, not sure what else to check.
Mining RVN on T-Rex
Just updated to 470.82.00 (was on 460.xx), so will check the results after a few minutes.
I also dropped PL to 170, still getting same MH so far.
Hi! you are being cut off by the PL, with that PL (140) your clock cant go over 1400 (aprox).
This is my Palit 3060ti, here is summer (35c outside) so it is a little warm, have been minin for an hour without rejecteds, look my PL is not set, so the card power swings over 140w and 155w.
Pretty stable hash between 43.2/43.9
2 Likes
These are the best setting I could find for my Gigabyte RTX 3060TI Eagle OC LHR for Ethash
I hope it helps someone
getting @47 Mhs
These are my settings with Gigabyte RTX 3060 Ti GAMING OC PRO 8GB GDDR6 - LHR
nbminer 39.6
I’m using 1 to 4 pci-e module because MB has only two pci-e slots.
I’ll try your setting for memory and pl.
3 Likes
My cards do not support more than 2700 Mhz mem clock. Every try over than 2700 cause a crash.
Here are the latest settings
“lhr”: “0,74,73.5,74,74”
Hi,
What is you best speed from MSI 3060 Ti Ventus x2?
Brother every card is different and have different OC limit so if its not going above 2700 mhz why are you trying to push it
Anyways you are getting +46 mhs some other card dont go 43 or further.
1 more advice use nbminer latest version and don’t put in any command for lhr keeping OC same as above and just change the PL to 120
So basically you will get 46-46.5 mhs stable at 119 watt
CHEERS !!!
1 Like
Just don’t buy an MSI
1 Like
MSI GEFORCE RTX 3060 TI GAMING Z TRIO 8GB LHR V2
Which oc setting do you use to get stable value?
Hello, is what on the print screen. This card not stable for some how. Or maybe i need to change a miner. Im not sure.
Realy? just scroll up
Do you try to use my settings? i share all information. miner ver. hiveos ver. nvidia ver.
what are your settings? can you post a screenshot?
I just started
How are things working with your cards? Slight degradation in my hash rate, but still stable and good overall share production.
msı 3060ti gaming z trio lhr v2
here’s my settings
Which do you think is the most logical and profitable pool?
1 Like
