yeah that’s how vegas are, but once you found the stable oc you’re set for good.
I had 1 week before i got rid of dead gpus. somehow you have to configure the card 1 by 1 until you found a good mix and match.
Mh, after installing the RX 570 8G, my Gigabyte Vega 64 (flashed to Vega 56) are restarting with GPU Deads.
Should I just leave the 570 out of the system?
Hi, I’m new to flashing, so i just need advice for chosing bios.
I have:
1x Sapphire RX Vega 64 8GB
113-D0500110-O01
and
5x Asus RX Vega 64 8GB
115-D050PIL-100
Found bios for sapphire:
And for strix:
Is this bioses safe to flash on this cards?
Thank you in advance
Is there anyway to identify the following parameters in Hive OS? I do not have access to a PC to install the card into to get Device id and Subsystem ID. I would like to flash my 64s to 56. This is what I find in Hive OS
these are fine and working well. i tested them as i have these kind of gpus. though asus strix model are like to consume more volts compared to other models.
might be your PSU is having trouble to power them all with the rx 570 included. i’d say its the power. i always use the model of not using more than 80% of the PSU’s load capacity.
its the number at the bottom of your GPU.
Example 03:00.0 and 07:00.0
Thanks for the response. Any advise on the correct 56 bios to use for these 2? New to this mining and flashing 
and wouldnt want to brick it just yet
Thank you. Cards are flashed to 56.
Is core 1075 / volt 870 / 1050 and straps from 1st post ok for them?
I am using the HP server psu with 1200W. I have also installed a power monitor on the wall.
It says 819 W in total for the rig.
My biggest concern actually is, that the MSI Air Boost Vegas are going to 80-84 °C. The Gigabytes sitting around 73 °C.
I have just a 30 cm ventilator sitting in fron of the rig and blowing in the direction of the window. But I have to do something here…
I’m trying this now but every time I apply the 56 bios Ron flash is ok then on reboot hive freezes. And help would be great. My card is a sapphire nitro + vega 64.
Any advice for a sapphire nitro + vega 64 every time I glash a 56 bios flash is ok then reboot just hangs on hive boot screen . I tried the flash on both bios settings and it never boots after. Flashed back to standard bios and I get a terrible 22mh/s @ 160 watts. Please help I’m gutted this card was £600
Hi, I have a red devil vega64 , i managed to found 56 bios with same device ID but different subsystem ID, do i still able to flash it with different subsystem ID rom? Thanks
use this
use this
hi, same device id but different subsystem id, is it safe to use?
can you post a screen shot of your sys id, use gpu-z
I had successfully flashed to vega56 bios by following your guide. Felt so good to see the hashrate stable at 55mh. Great thanks and appreciated.
yeah, mining efficiently feels great getting the max hash you can get happy mining.
