Is autofan enabled?
Run selfupgrade
in the shell also
Is autofan enabled?
Run selfupgrade
in the shell also
At present, there are three 6800 cards, one 6700xt card and two 7900xtx cards on my device. Except for one 7900xtx fan which is not controlled, all the others are normal and no automatic fan is turned on
I also found that my 7900xtx fan is currently set to 95, if I enter the miner stop command, after the command takes effect, the 6700 and 6800 fans are still 95, but the speed of the two 7900xtx is displayed as 0, and after entering the miner restart again, the other fans are 95. Only a 7900xtx or more than 30
Can you post a screenshot of the workers overview tab?
I just re-installed the driver in amd-ocl-install 5.7 a few days ago, I don’t know if it can be successful
can you show a bit less cropped? showing kernel/driver/hive version etc?
You need to run selfupgrade
selfupgrade new 0.6-225@240407?
Does the fan control work on the first one? But not the second?
The first 7900xtx fan can be controlled, the second can not be, I removed the second on the windows system can be controlled with AMD official driver
Are they the same model? If you switch places of the 2 7900xtx can you still control only the first one?
both 7900 XTX cards are the same brand and model, ASUS TUF series
I’ll give my feedback tomorrow after I swap this 7900 XTX on windows OS with the one on hive is that has a normal fan and try the results again!
Im curious of the result
Now I have exchanged the graphics card on windows system with the graphics card on hiveos, and the fan of this graphics card on hiveos can be controlled normally, but at present, there are only 7900xtx and 67006800 on hiveos, and the fan of this graphics card switched to windows can be controlled normally
The translation software I used may not be accurate, let me redescribe it, the GPU0 fan is normal in the picture above, and the GPU2 fan is abnormal in hiveos.
I removed GPU2 and put it on windows, and it was fine, and GPU0 was also fine on hivwos
Today I switched places with GPU2 (windwos) and GPU0 (hiveos)
Now GPU2 is normal, but now its number is the first on hiveos devices
I speculate that the current overclocking script can only be in the device at the same time there are two 7900xtx May have a graphics card control