Same here, my Zotac Trinity mining about 39,9 and somethimes it drop to 36-37 is it mean that its thermal throtle ? i cant check my memory temp(hiveos) oc 1500,2200,250 Autofan 59s(min fan speed 71)
any ideas ? is it thermal throtling or bad oc?, anyway when i touch backplate its hot(i can hold a finger about 2seconds) is ur backplate also that hot?
I have this same guys.
I`ll try now nbminer.
EDIT: for last 13 minutes it seems to be OK
Just simple question. Who of us uses dummy plug ??
I do not.
What about ur backplate?
I dont use any hdmi dummy
My backplate is HOT
after few tweaks, and running NBminer, i`m having stable 39.1 for 245W.
220/2200/245
If your gpu low performance it is due to heat in the memory junctions.
You must replace thermal paste and heating pads.
With that it keeps the hashrate continuous and gpu more stable
Hi guys,i buy 4x3070ti aorus,in friday arriving to my home,i need some settings for those,can someone share?
Clock,memory,Pl
I using 1500/2350 PL one 262 second 240
Stable 40mhs/each but i had to instal radiator and cooler on a backplate to cooldown memories, its cheaper than replacing thermal pads
I try it tommorow mine,guys how much power yours gpu need?
Mine need 2*8pin+6pin and have huge cooling system
My card is mining at 46,7 Mhs. Using T-rex for ETH.
Fan 70%
Mem -200
Clock 3400
Power 180W
No rejected shares and temp around 50.
See you!
Printscreen pls to see that.
Now it’s abit better… Changing miner to nbminer 39.2 we are getting 52 MHS in ETH mining. See below:
Hello, i could get 54-55 in ETH in my 3070 TI Cards using nbminer 39.2, Just switched 1 to RVN because i want to avoid Gas Fee on Ethermine, but you can see a clear diffence on consumption and heat.
is it the asus TUF? do you need to reapply the new thermal
paste? I applied new thermal paste for mine yesterday and temperature of core and hotspot increased. The temp for vram decreased but it still reach 105 after maximum overclocking
I was struggling to stabilize my 3070TI Zotacs until I found this configuration. I’m using Phoenix pool. 15 days without interruption, only those small flickers that we can see in the image. No overheating. Pretty much stable right now. However, I’m trying to find out a new configuration to rise every card above 50MH. I think is possible.
My friends using latest nbminer and with similar clocks have around 57mh
Exactly what I’m looking for. Can you find me a print screen? I’ll really appreciate it.
Same oc like yours but using latest nbminer,try it
here is what i use for ETH stay solid 57~58 power can move up and down a bit but seems to stay around 200 but will spike to 280 sometimes and hit the higher 58 mhs area then back down to 57.5 or so @ 200 watts
fan 65。 1060。2600。190-200。 56-57mh
