I use Dpm 3
1 Like
DPM states are no use and i am going to explain why:
The RX 570-580 card has 7 DPM states - meaning it specifies with each DPM state what core clock and voltage for the core to use. Examples:
DPM 1 700 clock - 700mv
DPM 2 1000 clock - 750mv
DPM 3 1100 clock - 800mv
these are examples.
but you dont need DPM states because you explicitly tell the card : use core clock 1140 mhz and run it with 850mv.
if you tell it later use DPM 3 , which one will it use ? your settings 1140 , 850 or the DPM state 3 which states use 1100 clock and 800 mv?
it neglects the DPM and uses the more specific settings.
so DPM states are not needed , also memory states are the same, you have 2, actually 3,
0 300mhz 300 mv
1 1000mhz 1000mv
2 2000mhz 1000mv.
Memory voltage cant be controlled on the RX 5XX cards so dont specify it.
Just put memory controller voltage 800.
u do need to set mdpm if mem controller voltage is not set,right ? I see big difference in consumption if mem state is not set right?..i have few cards that dont like 800 mem voltage and tho its not set, only mdpm 1
1 Like
if they dont like it increase it a bit. otherwise mdpm is 1000. it doesnt matter if memory state is 1 or 2 . if you go to your bios and open it with polaris bios editor you can see that all the states are with 1000mv setting
1 Like
I have it, if you still need it 
https://drive.google.com/file/d/1-1KNoALcg_B28MAF_MTv9ZuAAJCJxq0a/view?usp=sharing
Hi
I modulated the BIOS from the polaris
Please advise me with what settings to reduce the voltage consumption with the same hshryt
My graphics are in a room with a fan in front of it
Ref now : 30
you can try to reduce a bit the core voltage but if they crash it means it needs to be high. did you insert memory controller voltage 800 ? also did you switch the aggressive undervolting ON?
no i didn’t insert memory controller voltage 800
yes the aggressive undervolting is ON
I have never brought the core voltage below 850 In the pictures, I saw that with the same numbers, the voltage is close to 80, but for me it is 95
put 800 and to memory controller voltage and see what happens .
my card with 1168 core, 865 core voltage , 800 memory controller and 2100 is 100 watts so yours are a bit better.
I heard that the memory voltage should not be manipulated because it is very sensitive
I reduced the core voltage to 825, but the Rig error reduced hshryt and did not bring some graphics, but from 96 watts to 91 watts.
I went back to 850
If you reduce something reduce it by 5. And dont worry about the memory. Mine is 800 volts the memory controller voltage
Thankful
So I change the memory voltage
Memory controller voltage not the memory voltage itself.
Now memory controller voltage is 800 and reduce 3 watt of any graphics
Another friend told me to use the team red miner software, but I do not know how
i am mining with phoenix miner currently it gives me better results.
in the flight sheet you can change the miner used. you can select team red miner of phoenix miner and see how it goes.
OK
I have not used any software before and I am in the viabtc pool
I will test And I would like to join flexpool
phoenix is drawing higher hashrate than it is in real. TRM is more fair miner in this term, and power managment is better.
1 Like