rkulov
I will try this and notify you
17s - Autofan: GPU temperature 511 is unreal, driver error!
04:00.0 Temp: 511C Fan: 100% Power: 16777215W
Always after like 2 min of mining, some card is off, whole rig is off with both settings @rkulov @ebola57
And with that settings i have like max 22 mhs and drop to 16mhs
511°C temperature report is typcial of a main board that does’nt support so much GPU
You should make your tries adding one GPU by one, see stability and get your top
It is only one connected, i disconnect other 3, and errors all the time, mainbord is brand new
Gpu temp is 43 degrees, but when mining is started its 82
You have to enable a Core state. I suggest 1 and toggle on Agressive undervolting
After it, set manually à Core voltage at around 950mV
This should decrease significantly your temperature
Set fan to 80% and lower them to finally get ~55°C
Still nothing, same problem, mining for 1min then gpu stop mining, i dont know wtf is going on with those cards
Start to lower the memory to 1750, core to 1050. Disable autofan. Had this issue with a ’ wrong’ vbios
Then make changes to your DPM and find out what fits.
I will try that, first I must change thermal paste tomorrow and I will try that, because when rig is online temperatures are around 43 degrees, but when I start mining it suddenly jump to 80 plus degrees in like a minute or two, and then some error popup, 511 degrees gpu, but thanks, will try that tomorrow after tpaste change @nonsocksnl
it does this because you dont have OC settings, and they start working at max which leads to heating. its like you are gaming at the time. you dont need core states. Your cards are not bios modded right? start with conservative settings: 1100 core clock , 900 core voltage, 850 memory controler voltage and 2000 memory. see how they run.
I had to put fan on 100% because temp is 70 degrees
But hashrate dropped from 24 to 19, mining on gminer
And yes, i dont have bios settings
you need to bios mod it. than you will see how it will perform with these OC settings you have and adjust them.
Forget VDDCI(memory controler voltage), leave it blank.
Ive just get them from service, they cannot he modified, I mean bios modified on windows, so how to do that on hiveos so I can see their performance @rkulov
you can do it on windows too but you need ati bios flasher i think it was. anyways.
in hiveOS. you select the rig, select the worker and go to overclocking tab.
click on download Vbios and the command will be sent to the rig. once ready click on the command and save the file on your windows PC. Download polaris bios editor, open the file with it and click on the one click patcher. save teh file with different name. you need to keep the stock bios, so save with different name the modded one.
after that you stop all mining. go to the same menu and after you are sure that you stopped all mining, click flash bios, select the modded file, select the RIGHT card ( the one that you downloaded the stock bios from ) and upload.
and then restart rig and test.
I have rx 580
And I am using these settings overclocks
Core : 1165
Vdd : 840,850
Mem : 2165
Having about 30 mh
Once I change them the temp gets high
Its not bios modded right?
This topic was automatically closed 416 days after the last reply. New replies are no longer allowed.