Ok, still pretty new to Hive and have a confusing one.
Got a mixed rig setup, boots and mines fine so far except for this one bug.
During boot the display will kick on when the drivers are loaded, I can then watch the boot until it goes to load the GUI. At this point I just get a cursor in the top left corner (does not blink) and a blank screen?
And yes, it is set to have the GUI enabled in the hive settings.
Not the end of the world but it would be really nice to be able to see the status on the monitor and interact with it directly if needed. Already had a few times this would of been nice.
Anyone know what is going on?