Farm not detecting worker after flashing and setting up config file

[BumbleCat]

After flashing into hard drive and setting up the config file, the worker is not detected. I have set up an ethernet connection and a wifi connection on the config file too.

I’ve been following this guide: https://www.youtube.com/watch?v=3Pw87g8Kkiw
and I’m stuck around 12:10.

I uploaded the config file into the Hive hard drive already, but it’s not recognized.

Thanks in advance!

[keaton_hiveon]

you can always run firstrun -f from the rig itself, you may need to verify youre connected to your network with net-test first though.