I keep seeing posts for CMP 50HX that are getting 80-90 th on prl. I cant seem to figure out how this is possible. My cards cant get 4th no matter what i do to them. Is there a rootkit or something for these?
1 Like
So, i cant figure out how to edit my original post so here is a reply. It seems despite there being multiple write ups and ways to unlock the cmp50hx cards by far the easiest way to unlock them is to run what is currently the latest version of rgminer. Just set that sucker up on a flight sheet and let it run for about a minute. if you monitor the miner you will see it download compile and aply an unlock for you. Nice part, its a persistant unlock ( i doubt it survives if you change the kernel ) so you can run that for a few minutes watch it unlock the gpu’s for you then switch to whatever your favorite miner is.
After using the RGMINER pickaxe, what is the increase in hashrate?
The most noticable increase was on prl where the card went from 3th to 80th.
Very good
Can hivros run 80TH without any operation after using RGMiner
That has been my experience, i prefer peakminer so after running rgminer and unlocking them i run peakminer.
The steps are the same. I have been running the machine for 60 minutes, but the hashrate is still only 35 TH
well, it might be a case of your mileage may vary. Here is what my 2 cmp50hx cards look like.
My first card seems to be a runt, i cant set the clock offset nearly as high without it generating errors.
The power consumption you wrote is too low. Try entering 190 watts. Also, I have an image here that integrates HIVEOS with CMP 50HX. Once this image is set up, it can run CMP 50HX with a hashing power of 80TH