I see you have installed the 460.39 drivers, whenever I try I get the error that hiveos no longer boots, how did you do that you can use the drivers?
If it won’t boot after installing 460.39, then atleast one of your GPUs is a rev2 LHR card.
Nvidia released 460.39 in jan. 21 and rev2 LHR card support was added later this year, around june. This is why it won’t boot up with 460.39.
howe I can finde out wich one is LHR1 and LHR2?
Ti GPUs are all LHR cards
for the others, here is a reddit post:
don’t forget to upvote
Are you sure, that this is not a nonLHR card? Those are supposed to do 45 MH/s
If this OC is stable atleast for 24h then it’s ok, but 170 watts is a bit too much
170 watt ???
ergo coin or eth?
Unable to install 470.86.
During install rig is disconnecting, what to do?
wait, after upgrade driver to 470.86… miner always had a problem.
GPU not detected. and need to reboot… every 1 hour. any solution ?
OC is not higher .
im using NBminer 39.6 .
im trying NBminer 39.7 and get error " Nvidia setting applied with error . " GPU clocks 1500mhz not supported. " .
before error nvidia setting, "error no temp "
try this:
- stop the miner
- reinstall nvidia driver to the latest version
- update nbminer to latest version 40.1
- restart rig
- stop miner
- run this command: apt install --reinstall -y nvidia-settings
- restart rig
See if it works out…
Source: https://hiveos.farm/guides-driver_upd/
I got two gigabyte RTX 3060’s that wont go above 26MHs
using Gminer 2.72. Any advice?
edit: I noticed on the rig itself it says LHR - N/A for those two cards.
Edit 2: I updated to 2.73 and it seems to work now. Issue is, I noticed on the Rig, it said DAG damaged, check OC for GPU 3. I am unsure what OC settings to use at this point.
ok i will try. thanks for advice
I know it’s a bit wild.
I use T-Rex miner LHR 75% and it’s stable so far (40 mins).
This picture shows a peak value, the total hasrate is ~ 97,5-100 MH/s
I am new to mining and have my 3060 PL set to 150 W. I get 40.7MH and the temp is 46 degrees and is stable for ~2 months. I thought if the temp is low enough (i.e. <50) then I am not damaging anything. Is this correct?
This topic was automatically closed 416 days after the last reply. New replies are no longer allowed.